Admin The Condensate Pan and the Jelly Film Every cooling cycle pulls water moisture out of the room air, cools it into water, and deposits it in the evaporator's condensate pan, where it's meant to drain away through a condensate line. That pa... AIRSIDE Aug 24, 2026
Admin The Blower Wheel Nobody Thinks to Clean The blower wheel is the component that moves air across the coil and out into the space. Unlike the filter directly in front of it, which gets checked and swapped on a visible schedule, the blower whe... AIRSIDE Aug 24, 2026
Admin The Evaporator Coil Cleaning That Is the Heart of the Matter It is tempting to remove coil cleaning from the invoice. The unit still runs. It still blows cold air. Nothing trips, nothing alarms, and the invoice looks a little lighter without it. This is true es... AIRSIDE Aug 24, 2026
Admin The Relay Click That Makes Several Sounds Beyond the main compressor contactor, most aircon units rely on a handful of smaller relays to stage fans, sequence auxiliary heat, or switch smaller loads on and off in response to the control board.... ELECTRICAL SIDE Aug 24, 2026
Admin The Disconnect Switch Living Outside in the Weather The disconnect switch, or circuit breaker, is the pull-out or lever-style box mounted near the outdoor condensing unit. It is installed so a technician or electrician can de-energize the unit safely b... ELECTRICAL SIDE Aug 24, 2026
Admin What Condensation Does to a Circuit Board Over Three Summers Control boards sit inside the unit's electrical compartment, which is a sealed, protected environment. In practice, most compartments are not airtight, and condensation forms inside whenever warm, hum... ELECTRICAL SIDE Aug 24, 2026
Admin The Ground Wire Nobody Checks Until Something Trips Every wired aircon unit has a ground wire bonding the cabinet, the compressor housing, and the motor frames back to a common ground point. Under normal operation, no current flows through it. Its enti... ELECTRICAL SIDE Aug 24, 2026
Admin The Wire Behind Every “No Fault Found” Call Property managers tend to assume that when a unit stops responding to the thermostat, the problem is something substantial like a failed board. There may be a simpler possibility — the low-voltage con... ELECTRICAL SIDE Aug 24, 2026
Admin The Wire You Can't See Until It's Already Failed Every running compressor and fan motor vibrates, and every wire routed near one moves with it — a fraction of a millimeter per cycle, thousands of cycles a day, for years. Where a wire passes through ... ELECTRICAL SIDE Aug 24, 2026
Admin The Amperage Trend That Predicts a Winding Failure Years Early A clamp meter reading on a compressor or fan motor is one of the few electrical numbers that reliably makes it onto a service report. What usually doesn't make it onto the report is the comparison fro... ELECTRICAL SIDE Aug 22, 2026
Admin The Compressor Terminal Nobody Wants to Touch Every wire that powers a compressor eventually lands on three small terminals pressed into the compressor's shell — the fusite. It's a glass-to-metal seal that lets electrical current pass into a seal... ELECTRICAL SIDE Aug 22, 2026
Admin How a Failing Contactor Gets Labeled as a “Pass” A contactor is a simple device: a low-voltage signal from the thermostat energizes a coil, the coil pulls a set of contacts closed, and line voltage flows to the compressor and condenser fan. It does ... ELECTRICAL SIDE Aug 22, 2026
